Actually, I’m still having the problem of uploading. I have tried the above, changing the jumper pins to the different voltage, or even without the jumper. I’m getting the following error:
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0xa5
It was working fine just yesterday. Now it has one red LED flashing every second. I have checked all connections too. Everything seems fine just as it was when it worked before.
Any help is appreciated. Many thanks in advance.
After it “attempts” to upload, the screen on the MAKERbuino goes blank, as if expecting data. When I retry the upload, the screen returns to the SD loader while it attempts to upload agian.
Nevermind!! I had the pins connected the wrong way round.
The board and the programmer pins have marked letters.
Make sure you have the wires/pins connected to the same pins, GND to GND, CTS to CTS etc.
Man I feel stupid lol.